ENGENIUS ENS500AC Wireless Access Point Outdoor 5GHz IP55

EnGenius ENH500 Wireless Outdoor CPE features 13dBi high gain antenna dual polarization with high output power and high sensitivity. It can increase the transmission range and deliver a stable wireless connection.
ENH500 integrates 4 operation modes: Access Point, Client Bridge, Client Router and WDS.

The ENH500 is convenient to build up an up to 25km long-range wireless link while reducing dead spots. Advanced multi-function operation modes offer flexibility while buildingn up a scalable wireless network for all possible applications. ENH500 is designed to deliver reliable service under
harsh outdoor environment with certified IP55 protection. It is tailored to accommodate multimedia streaming services with data rates up to 300Mbps. Most importantly, it has built-in encryption methods (WEP, WPA, WPA2, TKIP/AES and IEEE802.1x) ensuring maximum security and compatibility.

Features :
- 802.11a/n
- 2Tx+2Rx: 300Mbps, 1* 10/100 Ethernet
- High Power up to 28dBm (The Max. Power may be different depending on local regulations)
- Integrates a 13-dBi Antenna with polarization
- Specific WISP Mode (CB/ CR/ AP)
- IP55 Water proof design
- 24V PoE support
- Reset button on PoE injector
- MSSID, SNMP, Narrow Band Support, Bandwidth Management

Specification
High output power
Transmits high output power. Can be setup following different countries legislations.
High Data Rate
High speed transmitting rate up to 300Mbps with 2T2R 802.11n
Long-range transmitting
Transmit power control and distance control (ACK timeout)
Signal Strength Display
RF signal strength status shown by LEDs in 3 colors, making network build-up easier. LED indicators
have the best transmitting and receiving signals for traffic communication.
Multiple SSIDs
4 SSIDs supported. Each SSID can set itself wireless or WAN configuration

Networking
Narrow Bandwidth
Provides different bandwidth selections (5MHz/10MHz/20MHz/40MHz) for wireless communication.
PPPoE
Point-to-Point Protocol over Ethernet at Client Router mode. This function will keep trying when failed or disconnected.
PPTP
Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
802.11i & 802.1x
WPA, WPA2 & IEEE802.1x Authenticator

Management
Firmware Upgrade
Upgrading firmware via web browser, settings are saved even after an upgrade
Reset & Backup
Reset to factory default. User can export all setting into a file via Internet
Ping & Trace Route
Built-in PING function & Trace Route function in Web GUI
MIB
MIB I, MIB II(RFC1213), Private MIB
SNMP
V1, V2c